H91-1003 the DSP board that performs the LPC analysis the system runs in real-time
J79-1060 ar imposed on the same set of LPC analysis parameters to produce the two
N03-2031 peaks were obtained through an LPC analysis . The outline of this paper is
N03-2031 magnitudes were computed based on an LPC analysis using 12 poles followed by a
W98-1436 characteristics of the filter . We used the LPC analysis method , which is one of the
H89-1040 transforms , filter banks , or LPC analysis . 3 . The frequency-position
J79-1060 the store " from a single set of LPC analysis parame - ters , varying only
H89-1016 analysis with order 14 is followed by LPC analysis with order 14 . Finally , 12
H92-1013 kHz sampling rate . 10th order LPC analysis was then performed every 10 msec
H93-1093 mel-cepstra derived from filterbank and LPC analysis . RECENT ACCOMPLISHMENTS The
H90-1033 autocorrelations are taken for LPC analysis , the length is limited by the
H92-1080 signal every 10 msec . A 32nd-order LPC analysis is used to compute the 12th-order
H92-1037 signal every 10 msec . The 32-order LPC analysis is followed to compute the 12-order
C94-2157 natural voices were run through LPC analysis and re-synthesize . d in order
W15-5111 10 ms ) . This is followed by LPC analysis that estimates the coefficients
J79-1060 on the speech data disk of the LPC analysis parameters . ( 2 ) An identification
H89-2039 then pre-emphasized . A 10 th LPC analysis is performed on a Hamming-windowed
H89-2038 has been achieved for lath order LPC analyses using diagonal covariance assumption
J79-1060 pitch contour is combined with the LPC analysis parameters retrieved from disk
hide detail